favorite
favorite
hide
unhide
flag

Posted

print

1967 Camaro Body Shop special (West Milford, North NJ)

1967 Camaro Body Shop special 1 thumbnail1967 Camaro Body Shop special 2 thumbnail1967 Camaro Body Shop special 3 thumbnail1967 Camaro Body Shop special 4 thumbnail1967 Camaro Body Shop special 5 thumbnail
bearfort

google map

make / manufacturer: Camaro / Chevrolet

more ads by this user

I have a 1967 camaro project for sale that needs the restoration finished.

This is a running drivetrain that was taken apart to repair the body. There is cross bracing installed ready to cut out the rockers/floors, on a mobile frame jig ($1500) included with car.

-New in box AMD sheet metal, floor, trunk floor, tail panels, quarters, 1 door/ 1 doorskin, inner rockers, outer rockers, front and rear new lower RS valances, rear subframes, etc. (cost > $5,000)
-Detroit Speed mini tubs with offset spring shackles (cost $600). Allows for a 315 mm wide tire!
-new leaf springs 1.5" drop (cost $450)
-Front subframe with power disc brakes (SSBC MD123A), power steering and a 350 V8 / TH350 3 speed automatic transmission running combo.
-Engine has Edelbrock top end, Elite series Valve Covers, Performer dual plane aluminum intake, Performer 600 CFM carb 1405
-10 bolt drum rear. Open differential (non-posi), drum brakes.
-bumpers, driveshaft, all glass, flat hood, fenders, inner wheel wells, original doors, trunk lid, tailights, chrome window trim, rims (tires need to be replaced)
-Big Block heater box cover, entire heater box.
-Black interior (minus headliner), bucket seats, back seat, center console.
-Factory gauge cluster AND aftermarket gauge cluster (Covans 6 gauge kit 500536, tach, speedo, oil, water, volt fuel).
-Ididit tilt steering column
-Gas tank, sender, vehicle wiring harness (gauges are already wired)

Passenger side toe board replaced, heater box opening on firewall modied from SBC to BBC design for more valve cover clearance (LS install?). Drivers side toe board replaced. Currently working on driver side inner/outer rocker panels. I will continue repairs until sold. Asking price will go up as repairs are made and materials used.

Clean NJ title (24,134 miles, Blue exterior) in my name/address, car started life as a gold basic 6 cylinder from the Norwood factory. My plan was to convert it to an RS setup with hide-away headlights, turn signals in the lower valance and reverse lamps in the rear lower valance.


It is NOT a COPO, Z28, ZL1, Nickey, RS, SS or even a V8 from the factory so customize it the way YOU WANT.


Would like to sell everything together but will work with cash buyer if you don't want some parts so you can go the dyancorn body or LS route.

-Body shell ONLY with NJ title $7,800 obo.
OR
-Body shell ONLY with NJ title on frame jig $8,900.
OR
-Body shell with NJ title and all sheetmetal (NO subframe/disc brakes/PS/engine/trans/rear/interior parts) on frame jig $12,750.
OR
-Camaro with all the stuff above $15,600 obo.

Let me know if interested. Car and all parts are in my garage in West Milford NJ 07480.
No checks, no BS, CASH only.
If ad is still posted then I still have the Camaro.
If you are interested include a call back phone number in your email.

***Any emails not containing a call back number are BS and will not be responded to***

Thanks
Sean

post id: 7759204981

posted:

updated:

best of [?]

loading
reading
writing
saving
searching